pcut40
pcut40

INVERTER PLASMA CUTTING MACHINE – CUT-40

brand-danox



    Product Description

MODEL CUT-40
Input power voltage (V) AC220 ±15% (1 Ph)
Input power capacity (KVA) 4.8
Input voltage frequency (Hz) 50/60
No load voltage (V) 230
Output current (A) GTAW / TIG 20-40
Arc ignition Nil
Output voltage (V) 96
Duty cycle (%) 60
Efficiency (%) 85
Insulation class B
Weight (kg) 8
Dimensions (mm) 371x155x295
Protection class IP21S
Genuine cut (mm) 6
OPTIONALS AVAILABLE ACCESSORY
- 3 Horse Power Air Compressor - PT-31 Plasma Torch Complete With Sleeve
6m Pressure
- Regulator With Filter
- Earth clamp With Cable STD
CHARACTERISTIC
- Less consumption of electricity, light weight,
high frequency, built in protective circuit to
prevent over heat, over current, over or under
voltage and ECONIMICAL.
- Feed-back circuit is controlled by advanced IGBT technology, stable output.
- Cutting current can be adjusted continuously from 20Amps to Max current, be able to meet the demands
of different materials, thickness and cutting speed.
- Non-contact arc starting mode without HF, little interference to the nearby electronic equipment.
- Applicable to cut carbon steel, stainless steel, galvanized steel, copper and aluminium, etc. With protection functions of short phase, over or low voltage, overheat or low air pressure.

Reviews

There are no reviews yet, would you like to submit yours?

Be the first to review “INVERTER PLASMA CUTTING MACHINE - CUT-40”

*

© 2017 Danox Welding Pte Ltd. All Rights Reserved. Design by Exhibit Media Pte Ltd